|
 Spiral Bracelet
This simple knot can be done with with any kind of cord
or embroidery floss. You can also knot in beads.
You Need:
Instructions
Fold cord so you have one 1' length and one 5' length. Tie a knot at
the fold to form a 1/2" loop.
 Your 1' length with be your holding cord and the 5' cord will be
your working cord. Tape the looped fold to your work surface and the end of your holding
cord to the table.
Make a knot by laying your working cord over top of the holding
cord; then passing it underneath the holding cord and through to loop formed. Pull snugly.
Continue knotting, letting the cord twist naturally as you work. Be careful to always knot
in the same direction.
When you have a long enough bracelet to fit around you wrist, string
two mini pony beads onto each end. Trim ends. Tie on your wrist by drawing one end through
before knotting.
©2000 MakingFriends.com, Inc. All
rights reserved. |
